THIS PAGE REFERS TO AN OLDER VERSION OF DOMAIN TIME. CLICK HERE FOR INFORMATION ON THE CURRENT VERSION.
This page appears only on Master and Independent servers. It specifies the timing settings recommended to Domain Time II Full Clients
when they synchronize to this machine or its slaves. Thin Client, Ultra Thin Client, and Domain Time daemons are not affected by these settings.
The Domain Time II Control Panel Applet - Client Timings Tab
Recommend these settings to clients that ask for guidelines
Checking this box causes the master and its slaves to suggest the client timing settings on this page to Domain Time II
Full Clients that have the Accept Server recommended timings box checked on their
configuration page. These clients will begin using the settings as soon as they sync with their time source.
Note that these options apply only to Domain Time II Full Client for Windows. Domain Time II Thin Clients, DTSet Command-line client, and
UNIX/Linux daemons do not have automatically adjustable timing settings.
The options on this page will be greyed out when this box is unchecked.
After client sets this machine's clock, it should check again...
Use these settings to specify how often Domain Time Full Clients should check their time against their trusted time source after
having successfully set their time at least once from that source.
As often as needed to maintain milliseconds sync with server
Choose this option when you want the client to automatically try to maintain synchronization with the source within the
range of milliseconds you specify. The client will synchronize often enough to maintain this level of accuracy.
Over time, Domain Time trains the system clock to be more accurate, so the number of times the client will need to sync to
stay within the target range should decrease. See Clock Training for more info.
If you choose to use the automatic accuracy targeting, be sure to select a realistic value. Choosing to have the client try to
maintain too small a variance will cause generate extra network traffic without necessarily improving the accuracy.
In particular, be sure to pick a value that is not smaller than the best resolution of the time protocol
Only every (Select desired period)
Instructs the client to synchronize on the fixed schedule you select.
If client cannot set this machine's clock, it should try again in...
This sets how often the client will retry to obtain the time if the trusted source is unavailable. The default for
this option is 5 minutes.
This section details how Domain Time handles corrections to the local system clock if it determines that the trusted
source has a different time.
Clock must be off by at least milliseconds before it is corrected
This indicates how large an error in the local clock is considered normal before Domain Time makes a change. Clocks
speed up and slow down during normal operation, and this setting allows your system to vary within an accepted range
without Domain Time intervening.
Once again, be sure not to specify too small a value, as this will generate an excessive number of corrections (and
corresponding entries in the log).
If correction applied, any amount of correction is okay
Instructs the client to change its clock to match the source, regardless of how drastic the change.
This is not a recommended setting under normal circumstances due to the fact that if the source has a wildly wrong time,
many applications can have errors if clock gets adjusted forward or backward by a large amount. If you have any machines
that are greatly out of sync, be sure to account for this type of potential problem before allowing Domain Time to
change the time.
Only accept corrections of under minutes
When this button is selected, the client will refuse to set the time if the variance between the client and the
time source is over the limit that you set. This is the recommended setting to avoid problems with wild corrections
Domain Time also includes built in "reasonableness" checking before accepting large corrections. Read more about this
on the Clock Target Seeking page.
There are two important exceptions to the above setting:
Domain Time II Full Client will accept any amount of correction when it first starts up. This is
to account for machines whose CMOS clocks aren't working, or that have Y2K-related
clock or BIOS errors.
The client will accept any amount of correction when you click the Sync This Machine Now
button on its Control Panel applet (or the equivalent from Domain Time II Server, Manager or the DTCHECK utility).
This allows you to get the clock into sync regardless of its current status.